Pratica di Shadowing: Step-by-step Demonstration: High-Voltage Battery Repair - Impara a parlare inglese con i video
Creazione lezione...
1
We're here at Precision Auto Service in Langley, BC, where a customer has brought in a 2016 Fiat 500E for repair.
2
The car was towed all the way from Vernon, BC, over 400 kilometers away from the shop.
3
The customer reported that the car would not go into ready mode.
4
The dealership had told the customer
5
that the entire battery pack would have to be replaced at a cost of around $20 ,000, and that was if a replacement could be found.
6
Precision Auto's diagnosis revealed a fault within the battery pack control module.
7
Replacement BPCMs are not readily available either, but Precision Auto is well connected and was able to source one from a company in Europe.
8
After the replacement module arrived, it was time to perform the repair.
9
The first step is to disconnect the 12 volt battery.
10
Yes, most EVs have a 12 volt battery to run accessories like lights, wipers and infotainment systems.
11
Next, the high voltage service plug is removed.
12
On this model it is located under the rear seat.
13
The service plug is like a giant fuse, this one is 350 amps.
14
Once removed, the high voltage is isolated to the inside of the battery pack, making it safe to work on the vehicle.
15
The battery pack is removed from under the car, so the car is lifted with a hoist.
16
On the Fiat, the battery pack extends from just rear of the front wheels almost to the back of the car.
17
The rearward part is where the fuel tank would be on a gas -powered car.
18
Several metal protective covers are removed.
19
This exposes the main high voltage cables, which are colored orange, and the cooling system hoses.
20
This battery is liquid cooled.
21
Even though the high voltage battery has been isolated, the technician puts on rubber electrical safety gloves before proceeding with the next steps.
22
To ensure there are no pinholes, the gloves are tested before each use.
23
This is done by rolling up the open ends of the gloves, pressurizing the air inside.
24
Then the gloves are held to the cheek to check for air leaks.
25
Once the gloves have passed the test, a pair of work over gloves are worn over them.
26
Now the technician is ready to disconnect the electrical cables from the battery pack, starting with the main line and then the secondary line.
27
He places a catchment vessel on a scissor lift table directly beneath the coolant hoses,
28
clamps the hoses, and then loosens the clamps where the hoses connect to the fittings on the battery pack housing.
29
The coolant drains into the catchment vessel.
30
to prevent further spillage while the battery pack is being removed he places caps on the coolant fittings
31
because the battery pack goes over the top of the rear axle the complete rear axle and suspension is removed.
32
When the battery pack is removed, it is going to drastically change the weight distribution of the vehicle,
33
so the technician secures the front and rear of the vehicle with supports beforehand.
34
The technician places the scissor lift table beneath the battery and raises it until it contacts the bottom of the battery case.
35
Now the main bolts can be removed
36
With all the bolts removed, the table and battery pack are lowered together.
37
This vehicle had a considerable amount of mud caked on its underside, so the battery pack cover must be cleaned before it can be opened.
38
No debris should be allowed to contaminate the interior of the battery case.
39
The technician uses a shop vac and compressed air to remove loose mud and dust.
40
Several dozen bolts hold the top and bottom halves of the battery pack case together.
41
These are removed.
42
The top half of the case can now be lifted off, exposing the components of the battery
43
The technician conducts some tests, verifying voltage readings to ensure there are no other problems.
44
Satisfied with the results, he disconnects the cables from the connectors on the BPC -M and removes the module.
45
He then installs the replacement module.
46
The battery pack is now ready to be reinstalled in the vehicle.
47
When an electric vehicle's high voltage battery malfunctions, it does not always mean that the entire battery pack must be replaced.
48
The most common reason a complete replacement will be recommended is
49
because currently there are very few businesses that possess the resources necessary to perform battery pack diagnosis and repair.
50
It is much easier to simply swap out the entire battery pack
51
that said the price of a replacement battery pack is usually prohibitive
52
and in many cases availability is scarce this will change over
53
time as with any new consumer product prices will come down as demand
54
and production increase this will be true not only for complete battery packs
55
but also for the internal components precision auto service is presently one of very few repair facilities
56
that have invested in the tools, equipment and training necessary to diagnose and repair high voltage batteries and other EV components.
57
This too will change as shops start to see a larger portion of their customer base driving electric vehicles.
✨ Video consigliato
C18
156 frasi
How Quantum Batteries Break Every Rule of Charging
Business EnglishUniversity StudentsWorking Adults
C11
106 frasi
EDFR GWO BTT Training Center - Nicolas Riou Wind
Business EnglishUniversity StudentsWorking Adults
B21
302 frasi
We Tore Apart Our Wrecked C8 ZR1… It’s Worse Than We Thought
Business EnglishUniversity StudentsWorking Adults
C12
40 frasi
Inside the Relay Controlled SF6 Circuit Breaker: Preventing Arcs and Ensuring Safety
Business EnglishUniversity StudentsWorking Adults
C13
99 frasi
12. Parallel Stent Retriever Technique in Mechanical Thrombectomy for Acute Ischemic Stroke
Business EnglishUniversity StudentsWorking Adults
C11
19 frasi
I Made an EMP Device... It Actually Works
Business EnglishUniversity StudentsWorking Adults
C14
140 frasi
PCB Inspection Methods & Common PCB Defects
Business EnglishUniversity StudentsWorking Adults
C11
166 frasi
What's The Best Supercharger? Roots vs Centrifugal vs Twin-Screw vs Electric
Business EnglishUniversity StudentsWorking Adults
C14
291 frasi
How The World's Most Powerful Fighter Jet Engine Is Made
Business EnglishUniversity StudentsWorking Adults
C14
28 frasi
Comparing Low Voltage Vs. Medium Voltage Equipment on Solar Sites
Business EnglishUniversity StudentsWorking Adults
C14
132 frasi
Intro to Pylontech’s US5000 48 Volt Lithium Battery
Business EnglishUniversity StudentsWorking Adults
B21
185 frasi
THAT Smart We've All Been Waiting for - smart #2 Static Review
Business EnglishUniversity StudentsWorking Adults
Vocabolario e note di pronuncia per questa lezione
Questo video contiene 57 frasi e 852 parole da ripetere con lo shadowing. Il parlato dura 8:46. Chi parla lo fa lentamente, circa 97 parole al minuto, quindi c’è tempo per imitare ogni suono. Solo il 77% delle parole rientra nelle 3.000 più comuni dell’inglese, quindi il lessico è impegnativo.
Vocaboli chiave di questo video
15 parole del video che vale la pena imparare, con pronuncia e significato:
| Parola | Pronuncia | Significato |
|---|---|---|
| voltage sostantivo | /ˈvəʊltɪd͡ʒ/ | voltaggio, tensione |
| replacement sostantivo | /ɹɪˈpleɪsmənt/ | sostituto, rimpiazzo |
| glove sostantivo | /ɡlʌv/ | guanto |
| technician sostantivo | /tɛkˈnɪʃən/ | tecnico |
| repair verbo | /ˈɹiːpɛɚ/ | riparare |
| precision sostantivo | /pɹɪˈsɪʒ.ən/ | precisione |
| hose sostantivo | /hoʊz/ | manichetta |
| component sostantivo | /kəmˈpoʊ.nənt/ | componente |
| bolt sostantivo | /boʊlt/ | bullone |
| automobile sostantivo | /ˈɔː.tə.məˌbil/ | automobile, auto |
| connect verbo | /kəˈnɛkt/ | connettere, connettersi |
| vessel sostantivo | /ˈvɛsəl/ | vascello, imbarcazione |
| diagnosis sostantivo | /daɪəɡˈnəʊsɪs/ | diagnosi |
| plug sostantivo | /plʌɡ/ | spina |
| expose verbo | /ɪkˈspoʊz/ | esporre, evidenziare |
I phrasal verb che sentirai
| Parola | Significato |
|---|---|
| roll up verbo | arrotolare |
La grammatica di questo video
Le strutture che chi parla usa di più, con le parole esatte del video:
| Struttura | Nel video |
|---|---|
| Forma passiva be + participio passato — conta ciò che accade, non chi lo fa | was towed · be replaced · is removed |
| Present perfect have/has + participio passato — un’azione passata che conta ancora adesso | has brought · has been isolated · have passed |
Pronuncia a cui fare attenzione
- I suoni “sh” e “zh”: technician /tɛkˈnɪʃən/, precision /pɹɪˈsɪʒ.ən/, suspension /səˈspɛnʃən/, dealership /ˈdiːləʃɪp/, malfunction /ˌmælˈfʌŋk.ʃən/
- Parole lunghe — attenzione all’accento: automobile /ˈɔː.tə.məˌbil/, electrical /ɪˈlɛktɹɪkəl/, considerable /kənˈsɪdəɹəbl̩/, availability /əˌveɪ.ləˈbɪl.ɪ.ti/, accessory /əkˈsɛs.(ə.)ɹi/
Come esercitarsi con questo video
- Ascolta tutto il video una volta senza parlare e annota le parole che non conosci.
- Fai shadowing frase per frase a velocità normale, ripetendo ognuna finché il tuo ritmo coincide con quello di chi parla.
- Registrati e confronta con l’originale, facendo attenzione a parole come voltage, replacement, glove.
Cos'è la tecnica dello Shadowing?
Shadowing è una tecnica di apprendimento delle lingue supportata da studi scientifici, originariamente sviluppata per la formazione dei traduttori professionisti e resa popolare dal poliglotta Dr. Alexander Arguelles. Il metodo è semplice ma potente: ascolti un audio in inglese di madrelingua e lo ripeti immediatamente ad alta voce — come un'ombra che segue il parlante con un ritardo di solo 1–2 secondi. A differenza dell'ascolto passivo o degli esercizi di grammatica, lo shadowing costringe il tuo cervello e i muscoli della bocca a elaborare e riprodurre simultaneamente i modelli di discorso reale. La ricerca dimostra che migliora significativamente la precisione della pronuncia, l'intonazione, il ritmo, il discorso connesso, la comprensione dell'ascolto e la fluidità del parlato — rendendolo uno dei metodi più efficaci per la preparazione alla prova di speaking dell'IELTS e per la comunicazione reale in inglese.