Prática de Shadowing: How does a nuclear power plant work? - Aprenda a falar inglês com vídeo

Escolha um modo de prática

Cada modo abre uma sala de prática em tela cheia.

42 frases
Se as frases estiverem muito curtas ou longas, clique em Edit para ajustá-las.
1
Electra -Belle has seven nuclear power plants, four in Doule and three in Tiange,
2
covering half of the electricity consumption in Belgium without producing CO2.
3
But how exactly does a nuclear power plant work?
4
A nuclear power plant works to a large extent like a conventional thermal power plant.
5
Water is converted into steam, which drives a turbine connected to a generator.
6
This generator converts the mechanical energy into electrical energy.
7
The only difference is that the heat, which converts water into steam, is produced by nuclear fission and not by burning coal, natural gas or biomass.
8
The nuclear power plants of Duhl and Tiange use fissile uranium oxide.
9
Uranium oxide is compressed into fuel pellets and packed into sealed fuel rods.
10
Multiple rods in turn form fuel elements which are immersed in water within a reactor vessel made of 20 cm thick steel.
11
The reactor vessel is subsequently hermetically sealed.
12
The fission of the uranium can now begin by bombarding it with neutrons.
13
In each fission, two or three neutrons are released.
14
They in turn cause new fissions and thus creating a chain reaction.
15
In a nuclear reactor, it's important that this chain reaction is controlled.
16
After each fission, only one released neutron should cause a new fission.
17
Boric acid in the water of the reactor vessel and lowered control rods absorb the oversupply of neutrons.
18
By lowering all the control rods at the same time, the chain reaction is stopped within 1 .3 seconds.
19
A nuclear power plant with a pressurized water reactor, such as Dool and Tiange, has three completely separated water circuits.
20
A primary circuit, a secondary circuit, a tertiary circuit.
21
In the primary circuit, the heat released during the fission of the uranium nuclei heats
22
up the water in the reactor vessel to the temperature of 320 degrees Celsius.
23
The pressure regulator keeps everything under high pressure, so the water does not boil or form steam hence the name High Pressure Reactor.
24
The hot water passes via the primary circuit to a heat exchanger or steam generator.
25
This is a cylindrical device with thousands of pipes in reverse U shape.
26
The water runs through these pipes and gives the heat to the water of the secondary circuit, which flows alongside the exterior of the pipes.
27
The water in the secondary circuit heats up and turns into steam.
28
The steam from the steam generators drives one or more steam turbines.
29
These turbines consist of a series of blades installed on a shaft.
30
The high pressure of the steam causes the shaft to rotate very fast.
31
This, in turn, drives a generator, which ultimately produces electricity, somewhat like a dynamo on a bicycle.
32
Transformers increase the voltage of the electricity produced by the generator, allowing transportation of the electricity to the end users with as little loss as possible.
33
To cool down, the steam coming from the turbines passes through a condenser.
34
The cooling water from the tertiary circuit passes through the tubes of the condenser.
35
In Dool, this cooling water comes from the schelder, in tiage, from the mass.
36
The steam from the secondary circuit condenses to water and is returned to the steam generator to be heated again to steam.
37
The warmed cooling water is brought to the cooling tower.
38
There, it cools through contact with an ascending airflow, the natural chimney effect as it were.
39
The majority of this water is collected in a basin at the bottom of the cooling tower
40
and then returned to the condenser.
41
Almost all the water is subsequently discharged back into the schelder or the mass.
42
Only a small part leaves the cooling tower as water vapor.

Baixar aplicativo

Tudo o que você precisa para falar fluentemente

Pronúncia com IANota em cada frase
Prática de IPADomine cada som
VocabulárioMonte seu banco de palavras
Jogo de vocabulárioAprenda brincando
FOR YOU

Vídeo recomendado

Vocabulário e dicas de fala para esta lição

Este vídeo tem 42 frases e 605 palavras para praticar shadowing. A fala dura 3:56. O falante fala em ritmo natural, cerca de 154 palavras por minuto, próximo de uma conversa do dia a dia. Apenas 70% das palavras estão entre as 3.000 mais comuns do inglês, por isso o vocabulário é exigente.

Vocabulário principal deste vídeo

15 palavras do vídeo que vale a pena aprender, com pronúncia e significado:

PalavraPronúnciaSignificado
circuit substantivo/ˈsɝ.kɪt/circuito, volta
generator substantivo/ˈdʒɛnəɹeɪtə(ɹ)/gerador
reactor substantivo/ɹiˈæktɚ/reator
electricity substantivo/ɪˌlɛkˈtɹɪsɪti/eletricidade
vessel substantivo/ˈvɛsəl/barco, navio
uranium substantivo/ˌjuː.ˈɹeɪ.ni.əm/urânio
turbine substantivo/ˈtɜː.baɪn/turbina
pipe substantivo/ˈpaɪp/flauta
convert verbo/kənˈvɝt/converter, transformar
seal substantivo/siːl/selo
subsequently advérbio/ˈsʌb.sɪ.kwənt.li/subsequentemente
shaft substantivo/ˈʃɑːft/haste, cabo
oxide substantivo/ˈɑksaɪd/óxido
tertiary adjetivo/ˈtɜː.ʃi.ə.ɹiː/terciário
extent substantivo/ɪkˈstɛnt/extensão

Phrasal verbs que você vai ouvir

PalavraPronúnciaSignificado
cool down verbo/kuːl ˈdaʊn/esfriar, arrefecer

Pronúncia para ficar de olho

  • Os sons de “th”: thick /θɪk/, thermal /ˈθɜːməl/
  • Os sons de “sh” e “zh”: shaft /ˈʃɑːft/, tertiary /ˈtɜː.ʃi.ə.ɹiː/, consumption /kənˈsʌmp.ʃən/, conventional /kənˈvɛnʃənl̩/, fission /ˈfɪʃən/
  • Palavras longas — acerte a sílaba tônica: generator /ˈdʒɛnəɹeɪtə(ɹ)/, electricity /ɪˌlɛkˈtɹɪsɪti/, uranium /ˌjuː.ˈɹeɪ.ni.əm/, subsequently /ˈsʌb.sɪ.kwənt.li/, tertiary /ˈtɜː.ʃi.ə.ɹiː/

Como praticar com este vídeo

  1. Ouça o vídeo inteiro uma vez sem falar e anote as palavras que você não conhece.
  2. Comece na velocidade 0,75×, faça shadowing frase por frase e volte à velocidade normal quando ficar fácil.
  3. Grave a sua voz e compare com o original, prestando atenção a palavras como circuit, generator, reactor.

O que é a Técnica de Shadowing?

Shadowing é uma técnica de aprendizado de idiomas com base científica, originalmente desenvolvida para o treinamento de intérpretes profissionais. O método é simples, mas poderoso: você ouve áudio em inglês nativo e repete imediatamente em voz alta — como uma sombra seguindo o falante com 1-2 segundos de atraso. Pesquisas mostram melhora significativa na precisão da pronúncia, entonação, ritmo, sons conectados, compreensão auditiva e fluência na fala.

Técnica de shadowing: leia o guia completo passo a passo →